INTRODUCTION Without
doubt, power interruptions cause major problems for home and business
computing. An unpredictable power supply can lead to worrying problems
events such as surges, spikes, brownouts and utility failures. If any of
these should occur, there’s a strong chance you will suffer from loss
of critical data, lowered productivity and even damage to your expensive
equipment.All
electrical and electronic equipment, connected to the mains supply is
at risk of being damaged from spikes, surges, lightning, brown-outs,
power-cuts (blackouts), power back surges, and over-voltage.UKMK
encompasses a wide range of power protection products for use in many
different industries where clean, regulated mains power is critical to
their continued operation.MK TV GUARDThe
TV guard is an overvoltage protection device rated at 5 Amps. The TV
guard will disconnect if the mains go above the upper limit and
re-connect automatically after the supply returning and remaining below
the upper limit for the duration of the wait time.PLEASE READ CAREFULLY1.
Make sure that your load does not exceed the rating of the TV guard
which is 5 AMPS. If this is exceeded, the TV guard may be damaged, and
the warranty will be void.2. Plug the TV guard into the mains and plug
your appliance into the TV guard.3. Do not connect more than one
appliance to the TV guard.4. On first switching on, the red LED will
indicate and there will be no output while the TV guard monitors the
mains. If the mains level is acceptable, the Yellow LED is lit
indicating that the TV guard is in wait mode. At the end of the wait
time (30 seconds), and if the supply is below the upper limit, the green
LED goes on and the load is connected.5. It is recommended that the TV
guard is kept switched on, and the appliance switched on and off as
required, to prevent activating the time delay every time the appliance
is switched on.SPECIFICATIONSMaximum
power 5 ampsNominal voltage 230VOver-voltage disconnect
265VUnder-voltage disconnect 180VSpike protection 160JMains spike
response time Less than 10nsMains spike discharge current 6.5kAWait
Time 30 secondsIdeal For TV, Video, Hi-Fi, PABX, Fax machines, Fridges
and domestic freezers and all electronic equipment up to 5AmpsSocket
availability UK13, Schuko, 5A Indian Weight 250gmDims 180x90x95mmTHE FRIDGE GUARDThe
Fridge Guard is an under-voltage protection device rated at 5 Amps. The
Fridge Guard will disconnect if the mains go below the lower limit and
re-connect automatically after the supply returning and remaining above
the lower limit for the duration of the wait time.PLEASE READ CAREFULLY1.
Make sure that your load does not exceed the rating of the Fridge Guard
which is 5 AMPS. If this is exceeded, the Fridge Guard may be damaged,
and the warranty will be void.2. Plug the Fridge Guard into the mains
and plug your appliance into the Fridge Guard.3. Do not connect more
than one appliance to the Fridge Guard.4. On first switching on, the
yellow LED will indicate and there will be no output while the Fridge
Guard monitors the mains. If the mains level is acceptable, the Yellow
LED is lit indicating that the Fridge Guard is in wait mode. At the end
of the wait time and if the supply is above the lower limit the green
LED goes on and the load is connected.5. It is recommended that the
Fridge Guard is kept switched on, and the appliance switched on and off
as required, to prevent activating the time delay every time the
appliance is switched on.6. If the red LED shows, the voltage is too
low. When the voltage is acceptable, the Fridge Guard will go to yellow.SPECIFICATIONS•
Nominal Voltage 230V (or 110V)• Current Rating 5Amps• Frequency
50/60Hz• Mains Spike Response Time less than 10ns• Mains Spike
Discharge Amps 6.5kA • Spike Protection 160J• Wait Time 90 seconds•
Ideal For Fridges, freezers and coolers• Socket availability UK13,
Schuko, 5A Indian • Weight 250gm• Dims 180x90x95mm