YN-622N will have full control in Remote Manual or TTL, in 3
separate groups. Manual power levels or FEC
(flash exposure compensation) can be adjusted in full or 1/3rd stops.
This allows ratios to be created when using TTL.
1. – Master on Top – With an SU-800, or
Master flash unit (set to master mode), mounted on top of the YN-622N
Transmitter, it will use the master units settings (Flash Mode / Power Output /
FEC etc). The flash mounted on top of the Tx can be used in TTL / Manual /
or Multi RPT mode.
2. – No Master on Top – Without a master
device on top of the Tx, you can also set the FEC/Manual Output (1/3 or 1 stop)
of 3 group A/B/C.
3. – Smart triggering – settings can be
made directly on the flash unit itself (equal to the current mixed mode
of the YN-622c).
4. – FP HSS, Rear Curtain Sync etc – 1st
Curtain Sync, Rear Curtain Sync, Auto FP HSS to 1/8000th, Red Eye Reduction,
and Modelling Flash are all supported.
5. – AF Lamp (Auto Focus Assist Lamp)
(Can be disabled if not necessary).
6. – In TTL mode the YN-622N works in the way of
Nikon CLS. That is each group is metering separately.
If you’re not familiar with the YN-622, the Canon
version YN-622C were somewhat of
a breakthrough in price and performance for inexpensive TTL
radio triggers.
Bringing the convenience of remote flash control from the
camera position, in both ETTL and Manual Power settings, to a very affordable
level.
With a retail price around $80 a pair they
were the lowest priced TTL capable radio triggers available, though still
offering a lot of capability for that low price.
For those more technically
inclined, the YN-622N have had to take full control of the remote
speelight in ITTL mode, even while doing remote manual power setting.
So the slave flash is always set to ITTL, even for remote
manual setting. This is more similar to the Phottix Odin (for Canon or
Nikon), than the YN-622C for Canon, which are able to follow Canons own
Optic Wireless protocol more closely.
Nikon have obviously made things a little more
difficult though, so there is a pre-flash in remote manual use as well, and
this is the same for the test fire button.