Linksys RE3000W N300 Wireless Range Extender
Extend the range of your home Wi-Fi signal and eliminate dead spots using the Linksys N300 Wi-Fi Range Extender (RE3000W). The RE3000W can be plugged into a standard wall outlet to bring wireless Internet connectivity to the far reaches of your home, with a range of up to 5,000 square feet. An Ethernet port allows you to establish a wired connection to a desktop or laptop computer or another Internet-capable deviceThe Linksys RE3000W Wireless-N Extender lets you repeat the wireless signal of any access point or router to provide Internet connectivity to hard to reach areas through a wired or wireless connection.
This Wireless-N range extender can be set up through
· Accessing its web-based setup page
· Using the Linksys Connect software if you have it installed on your computer
· Using the Wi-Fi Protected Setup (WPS) on the RE3000W if your router also supports it
· Using the setup software in the CD that comes with it
Front panel On the front panel of the Linksys RE3000W, the light has two (2) functions
Power - The power light is located on the front panel. It lights up when the range extender is powered ON. The light flashes slowly every three (3) seconds when the device is reset to factory defaults or during a firmware upgrade. When the range extender is ready for use, the light is continuously lit. If there is an error, the light flashes quickly (every second). Wi-Fi Protected Setup - When the Wi-Fi Protected Setup process is active, the light flashes slowly. When the WPS is successful, the light is continuously lit. If there is an error, the light flashes quickly (every second) for two (2) minutes.
Top panel Power port
This is where you connect the power adapter.
Wi-Fi Protected Setup(WPS) button
If you have client devices that support Wi-Fi Protected Setup such as wireless printers, this button automatically configures wireless connection and security after initial setup. If the extender is not associated to an Access Point and is not set up, pressing the WPS button will set up the extender to connect to an Access Point. If the extender is already set up and working in your network, pressing the WPS button will work to connect another client device to the extender.
Power switch
Powers the extender On or Off
Reset button
Press the Reset button for five (5) seconds to reset the range extender to its factory defaults. You can also reset the device from the Administration - Factory Defaults screen in the range extender’s web-based setup page.
Bottom panel - Ethernet port
The Fast Ethernet (10/100 Mbps) port works as a wireless bridge to instantly connect any wired Ethernet device to a wireless network. The green LED is lit when an Ethernet device is connected and active on this port. The light blinks when the extender is sending or receiving data over the Ethernet port.
Product Features
· Supports Wi-Fi Protected Setup for wireless client devices
· Can be set up using Linksys Connect setup software or through the web-based utility for manual configuration
· Security features include Wi-Fi Protected Access 2 (WPA2) security, which encrypts data on your wireless network
The RE3000W only supports Wired Equivalent Privacy (WEP) with hexadecimal format security key. If your gateway is setup with a WEP ASC II format, contact your Internet Service Provider (ISP) for assistance. The RE3000W Linksys Connect Setup Software is compatible with the following operating systems (OS)
Windows
Windows XP SP3, Windows Vista SP1, Windows 7, Windows 8
Mac OS X
Leopard 10.5.8 or higher, Snow Leopard 10.6.1 or higher, Lion 10.7 all versions, Mountain Lion 10.8 all versions, Mavericks 10.9, Yosemite 10.10