Stylish and compact A3 laminator. Just 3 minutes warm-up time. Suitable for 80-125 microns.

Features

● Hassle free laminating with excellent results, no complicated settings● Compact footprint makes it ideal for the home office desktop● Ready to use in 3 minutes - no more long waits to reach operating temperature● Low energy consumption, auto shut-off when the device isn't used for 30 minutes● For 80 to 125 microns● Takes approximately 60 seconds to laminate one 80 micron A4 sheet● LED ready lights and audible alert● Recommended for use with Leitz UDT Pouches

Instructions For USe

Setting up and switching on the laminator (1 and 2)

● Set the laminator up on a stable surface(e.g. table) close to a mains outlet (1). Ensure there is sufficient space behind the unit so the laminated item is not blocked and can easily be removed.● Connect mains cord with mains socket.● Put the ON/OFF switch in the ON position (2).● Put the temperature switch in the “I” position (80 mic) for pouches rated 75-100 μm. Put the temperature switch in the “II” position (125 mic) for pouches rated 125 μm. Put the temperature switch in the “0” position (cold) for cold seal pouches.

Inserting the document into the pouch (3)

● Insert the document into the laminating pouch. Align it to the sealed edge as much as possible and maintain even margins left and right. Pouches that are too large can be trimmed to size after lamination.

Laminating (4)

● When the POWER/READY LED indicator lights green, insert the pouch with the sealed edge rst until it gets pulled in. The laminated document automatically exits at the output side.

Letting the laminated document cool down (5)

● Remove the laminated document and leave it on a at surface for one minute to cool down.When you have no further documents to laminate, switch off the laminator.

Clearing a jammed pouch (6)Jamming can occur when laminating unsuitable materials.

CAUTION: To prevent any damages to the laminator, the pouch must be removed before switching off the unit.● Move the release lever to the right and pull out the pouch immediately.● Clean the rollers after any pouch jam as described in section “Maintenance and care”.

Maintenance and care (7)

In order to remove adhesive from inside the device, clean the rollers regularly as described here:● Switch on the laminator. Wait until the indicator lights green.● Fold a sheet of unused copy(80gsm) paper.● Insert the paper with the folded side first into the input tray 3–5 times.

To clean the housing:● Pull out trains plug and wait for the device to cool down.● Wipe the exterior with a soft, damp cloth and a dishwashing detergent.