Requires Compatible Flight Control SystemLightbridge works with select DJI multi-rotor flight control systems. Compatible flight controllers included: A2, WooKong-M, Naza-M V2, and Phantom 2HDMI and AV Video Input with Full HD TransmissionThe air-end module supports both analog composite and HDMI signals. When using HDMI resolutions of to 1080p at 30 fps can be transmittedLow LatencyThe video link features a latency of approximately 150ms. This makes the system suitable for FPV flying and aerial videography, where real-time feedback is essentialUp to One Mile Wireless RangeThe air end module supports a line-of-sight range of up to a mile, depending on environmental conditions and other variablesNote: By law, in the U.S. and many other countries, pilot visual contact with the aircraft must be maintained at all times.Built-in 2.4G Remote Control LinkNot only does Lightbridge relay video and OSD data back to the ground end, it also provides a way of extending the link between the transmitter (hand-held radio controller) and the aircraft. Plus, the Lightbridge system relays the gimbal control signal4.5 Hour Battery Life for Ground EndThe ground-end features a transceiver that is similar to a Wi-Fi router. It can be wall-powered, but since you will most likely be using it in the field there is also a built-in 4000 mAh battery lasting up to 4.5 hours. The battery can be charged with the supplied AC adapter or a 3S to 6S Li-Po batteryUSB 2.0 Port for Mobile DeviceThe USB port allows your Android or iOS smartphone or tablet to communicate with the ground end, and will display video from the camera on the mobile device's screen. Plus the port is powered so you don't have to worry about running down your device's battery. For Android users it is recommended you have Android 4.1.2 or aboveBuilt-In OSDThe OSD (on screen display) is natively part of the Lightbridge system meaning a separate iOSD module is not required. The OSD supplies telemetry data supplied by the flight computer, including, attitude/relative position, height, distance, horizontal and vertical speed, flight mode, power levels, signal strength, and GPS strengthAnti-Interference TechnologyUp to 8 downlinks can be connected for parallel streaming. Each can work independently without interference as long as proper spacing is maintained between themMulti-Device OperationA single air system can transmit to multiple ground systems, sending video to multiple screens at once. One ground system will send the control signal while additional ground systems receive the video signal onlyAdvanced SecurityGuards against third-party interception of the wireless link or loss of control over the aircraft to a third party. Plus encryption can be setup through the Lightbridge app

Specifications

Standards

PerformanceWireless Range: Up to 1 mile / 1.7 km (outdoor and unobstructed)EIRP: 1000 mWReceiver Sensitivity (1% PER): -101 dBm to ±2dBmWorking Frequency: 2.4 GHz ISMAntenna Gain Air End: 2.0 ±0.7 dBi at 2450 MHzGround End: 5.0 ±0.7 dBi at 2450 MHz System RequirementsOperating System: iOSAndroid: Android 4.1.2 or later Recommended Devices Samsung Galaxy Note3 QCOM, N9005, N9006Samsung Galaxy Note3 Exynos, N900Samsung Galaxy S4Samsung Galaxy MegaOptimus G ProLG Electronics G2Sony Xperia Z (L36h)Sony Xperia Z Ultra (XL36h) GeneralAntenna Connector Air End: MMCX MaleGround End: 2 x SMA Male Power Requirement Air End: 3S to 6S lithium-polymer (LiPO)Ground End: Internal battery or 3S to 6S lithium-polymer (LiPO) Power Consumption Air End: 700 mA ±20 mA at 12VGround End: 600 mA ±10 mA at 12V Operating Temperature: 14 to 122°F / -10 to 50°CDimensions (L x W x H) Air End (without Antennas): 2.7 x 1.9 x 0.8" / 68 x 48 x 21 mmGround End (without Antennas): 4.9 x 3.5 x 0.8" / 125 x 90 x 20 cmWeight Air End (without Antennas): 2.5 oz / 71 gGround End (without Antennas): 10.4 oz / 295 g

decorateTable('product-attribute-specs-table-1')