Press the “NO/OFF” button for 3 seconds and the red and blue lights will be on for 3 seconds. Wait about 40 seconds for the color of the lights to change to red lights, indicating that the boot is successful. Press the “MODE” button for 3 seconds, the light color changes to red and blue light lasts about 30 seconds, and then the light color changes to only red light again, which indicates that the camera has been successfully reset. (Please reset the device before use) When the (MV+ID) hotspot signal is found in the WiFi list of the mobile phone, it means that the device is in the waiting configuration state 4. Open the “V380 Pro” APP, 5. Click the “+” button in the upper right corner of the device list -> select [Add Camera] 6. Select [WiFi Smart Camera] 7. Select [AP hotspot connection] and follow the system prompts to continue operation 8. Select the WiFi that the device needs to configure, and enter the WiFi password -> click [Confirm] 9. Below Android 10: Select the device hotspot, and the mobile phone will automatically start network configuration after connecting to the hotspot Android 10 and above: Click [Connect AP spot] or enter the mobile phone system [Settings], select [WIFI], connect to the device hotspot (MV+ID), and the device will automatically connect to WiFi after returning to the app 10. Click the monitoring interface and set the user and password as shown in the following figure (the default password is empty when