هواتف محمولة و تابلت
كمبيوتر و برامج
موضة و جمال
كتب و ترفيه
## Product Description First of all, Arduino Uno R3 Chinese Clone is a microcontroller board utilizing the ATmega328P same like the Italian version. It has 14 digital input/out... المزيد عند تك ديبوت مصرتحقق منه على تك ديبوت مصر
## Product Description First of all, Arduino Uno R3 Chinese Clone is a microcontroller board utilizing the ATmega328P same like the Italian version. It has 14 digital input/out... المزيد عند تك ديبوت مصر
First of all, Arduino Uno R3 Chinese Clone is a microcontroller board utilizing the ATmega328P same like the Italian version. It has 14 digital input/output pins (of which 6 pins function as PWM outputs), in addition, 6 analog inputs, also 16 MHz quartz crystal, in addition to a USB connection, also, a power jack, an ICSP header, in addition to a reset button. It also contains everything to support the microcontroller. Just connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started. Furthermore, you can use your Arduino Uno R3 Chinese Clone without worrying too much about doing something wrong. Worst case scenario you can replace the chip for almost a few dollars and start over again.
Each of the Arduino Uno 14 digital pins on the Uno may serve as an input or output. Using pinMode(), digitalWrite(), and also, digitalRead() functions. They operate at 5 volts. Consequently, each pin is capable of providing or receiving 20 mA as recommended operating condition. Furthermore, each pin has an internal pull-up resistor (disconnected by default) a 20-50k ohm. The current provided by any I/O pin should not exceed 40 mAmps. If the current exceeds 40 mAmps this would probably damage the microcontroller permanently.
Also, some pins have specialized functions:
Also, the Arduino Uno has 6 analog inputs, labeled A0 through A5, each of which provides 10 bits of resolution (i.e. 1024 different values). By default, they measure from 0 to 5 volts. Furthermore, you can increase the upper-end range using the AREF pin in addition to the analogReference() function.
There are a couple of other pins on the board:
|Operating Voltage||5 V|
|Input Voltage (recommended)||7-12 V|
|Input Voltage (limit)||6-20 V|
|Digital I/O Pins||14 (of which 6 provide PWM output)|
|PWM Digital I/O Pins||6|
|Analog Input Pins||6|
|DC Current per I/O Pin||40 mA|
|Flash Memory||32 KB|
|Clock Speed||16 MHz|
عليك القيام بتسجيل الدخول